BOCA FGL PRINTER DRIVER

Although the printer can be written to across the network by this method, the data returned from the printer can’t be read back. You’re probably sending flash commands on every ticket. Normally, network interfaces supply to the host only: These drivers have very different operating modes. This command returns the IP address of the printer in the form. By using our site, you acknowledge that you have read and understand our Cookie Policy , Privacy Policy , and our Terms of Service. Can you determine if the printer is not responding to a particular packet or is going busy?

Uploader: Kazitilar
Date Added: 11 September 2009
File Size: 43.70 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 55706
Price: Free* [*Free Regsitration Required]

Click OKthen click Nextthen click Finish and wait a bit. This command permanently stores the selected port settings in flash.

Your printer may also be used as a Parallel printer if you have a Parallel port on your computer. Then it will wait 4s, then 8s, etc.

Please contact your software provider to confirm if the use of our driver is required for their ticketing software. Please note that margins must be adjusted to avoid printing outside of the ticket boundaries. Press the TEST button to enter that setting. Decide if you want to share the printer – if so, give it a ‘share’ name ex.

  CAMBRIDGE DACMAGIC USB DRIVER DOWNLOAD

javascript – How to print webpage via FGL printer (Boca System) – Stack Overflow

Sometimes it is necessary to run the printer on bboca indirectly connected network. If this is the case, the printer will automatically try and renew its lease before it expires. This driver is only to be used with PCL mode printers. FGL mode is discussed in great detail in the programming guide.

When I capture with Ethereal, why can’t I see tgl TCP packets other than packets to and from my machine, even though another analyzer on the network sees those packets? It is recommended that you bocw the same one we do so that the captured packet data can be analyzed here. In most cases you will select — LPT1 Recommended printer port. In the event that the item is not completed, the printer may initiate a timeout to close the port and discontinue the application see Retransmit Command Timeout.

Other operating systems like UNIX should have similar capabilities to the ones shown below. Please note that the printer cannot alternate between these two modes.

Installing an LPR port on Windows It will allow you pritner set the same configuration options available under the control panel Factory Menu.

At this point, any copy command issued to LPT2: The printer would always send packets directly to the destination host. Is the printer timing out during the retransmission of a packet or blca an idle state?

  COMPAQ PRESARIO V3736TU DRIVER DOWNLOAD

This address can be changed by the user see below. This command returns the Bocq address of the printer in the form. For other interface options, install the printer as you would any other printer. Please follow the instructions shown below to remove an old driver: This feature is still available in the new drivers to support old installations.

Sample Code

This driver is only to be used with FGL mode printers. It is up to the customer to reset it to 0. See the instructions below if you are using the Parallel to USB conversion cable.

Ethernet Diagnostic Modes should only be used after consulting with Boca Systems.

Windows – The most popular OS for your BOCA printer – BOCA Printers, Thermal Tickets & Wristbands

See the switch reference page on the Ethereal Wiki for information on some switches. Double click Add Printer. If not, it is sent to the Gateway Address.